I ren checkdisk in readonly (no repair) mode on the partition and it reported a lot of index errors in 1st step.I checked the partition via Windows and I can see (some) dirs there.I didn't hear from them since (more then 2 weeks now since). Also they told me they'll pass the problem to "research team".The basic level support told me that if I can view content of the partition then no damage was done to it. I disconnected the HDD with the partition so OS can't do any more damage to the corrupted filesystem. Since the partition moving process didn't finish, I believe (from my past experience) it must have corrupted the partition - the file system on it. I'm guessing it was somewhere 1/3 to 1/2 through the 170GB of data. In mid-process, while working with / changing the partition data. Then the app crashed and computer suddenly shut down.The app got to phase "Moving data: 50 GB/170 GB".I guess thats what "aligning" actually does - move the partition to new position (?) The process screen actually sayd "Moving partition".The app started after reboot in "PreOS" mode.(Cca 800GB partition on standard (non SSD) 1TB hard disk). I used AOMEI Partition Assistant Pro (5.x) to "Align" an NTFS partition with about 170GB of data.If by any chance you have any problem, take a picture and upload it to see what the problem is. If everything it's ok your Switch should boot into Armosphere 0.18. When the switch starts select Atmosphere and that's it. Turn off the Switch retrieve the card, put it on the PC, copy the contents of the zip again, turn on the Switch on RCM again, select the payload fusee-primary and inject it. select SD RAW 1, it should say Enabled with a green check. Select the part tha shows up in the next screen (usually it's the 1). Select emuMMC, create emuMMC, in the next screen select SD Partition (if it fails select SD File). When it's done, select Close, and then Home. Select Next Step to begin the partitioning. In the next screen the rd bar emuMMC (RAW) should stay at mid (29 GB). Put back the card into the Switch, go to Hekate, tools, select Arch bit If you already made the backup and copy to your PC, delete the partitions, leave the card as RAW and reformat it as FAT32, copy the content of the zip made in sdsetup and continue from this step You don't need to manually paritition the card, that is made in Hekate.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |